Preparing Cortoss
Allow the Cartridge to equilibrate to room temperature prior to use.
This may require approximately one hour.
|
|
Step 1:
Press and hold the Piston Release Button on the rear of the
Delivery Gun.
Using the Piston Rack finger loop, pull the Pistons into the
Delivery Gun housing until fully retracted.
|
|
Step 2:
Open the Cartridge Door on the Delivery Gun.
|
|
Step 3:
Hold the Cartridge so that the volume increment (numbered) side faces up.
Note: The Cartridge Notch (arrow) opposite the numbered
surface will engage the Delivery Gun.
|
|
Step 4:
Place the Cartridge, volume increment (numbered) side up, into the Delivery Gun and fully seat.
|
|
|
Step 5:
Close the Cartridge Door to lock the Cartridge
in place.
|
|
Step 6:
Push the Piston Rack fully forward until the Pistons stop within the Cartridge.
Remove the Cartridge Cap by turning it a quarter turn in a
counter-clockwise direction.
A gentle toggle of the Cap may facilitate its removal.
|
|
Step 7:
Balance the plungers by slowly squeezing the trigger of the
Delivery Gun until material is expressed from each chamber
of the Cartridge. Wipe any excess material from the end of
the Cartridge.
|
|
Step 8:
Attach a Mix-tip to the Cartridge by aligning the v-spike
on the Mix-tip with the corresponding v-notch on the
Cartridge. Press the Mix-tip firmly against the Cartridge
housing and rotate the lock ring one quarter turn clockwise
until it meets its mechanical stop.
DO NOT SQUEEZE THE TRIGGER AT THIS STAGE.
|
|